Regular maintenance, Warning, Checking /adding fuel – Simplicity 14HP User Manual

Page 22: Check/ change transmission oil

Advertising
background image

Regular Maintenance

A

WARNING

Gasoline is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do not
allow open flame, smoking or matches in the
area. Avoid over-filling and wipe up any spills.

Do not remove fuel filter when engine is hot, as
spilled gasoline may ignite. DO NOT spread hose
clamps further than necessary. Ensure clamps
grip hoses firmly over filter after installation.

CHECKING /ADDING FUEL

To add fuel:

1. Remove the fuel cap (see A, Figure 15).

2. Fill the tank. Do not overfill. Leave room in the tank

for fuel expansion. Refer to your engine manual for
specific fuel recommendations.

3. Install and hand tighten the fuel cap.

CHECK/ CHANGE
TRANSMISSION OIL

The transmission oil should be checked before each use

and changed after the first 50 hours of operation. Then
change the oil after every 250 hours of operation. The
oil should also be changed if it has become discolored
from overheating or contamination.

Transmission Oil Capacity: Apx. 3.5 Quarts

Transmission Oil Type: SAE

with a minimum

API rating of

Figure 15. Fuel Tank Fill
A. Fuel Tank Cap.

Do not use gasoline containing METHANOL,

gasohol containing more than

10% ETHANOL, gasoline additives, or white

gas because engine/fuel system damage

could result.

Do not allow dirt, water, or other debris to

enter the reservoir. Even a small amount of
dirt can irreparably damage the transmission

Checking the Oil Level:

.

Locate tne

on

rear

Observe the oil level. Oil should be up to the FULL
mark (see Figure 16). DO NOT OVERFILL. Empty
space is required in the reservoir tank for heat expan-
sion.

If necessary, clean the area surrounding the reservoir

cap, remove the cap, and add oil.

Changing the Transmission Oil:

Drain hydrostatic system by removing drain plug (see

Figure 17). Drain oil into a suitable container.

2. Reinstall the drain plug.
3. Add oil a few ounces at a time until the reservoir is

filled to the FULL mark. DO NOT OVERFILL. Empty
space is required in the reservoir tank for heat expan-
sion.

4. Run tractor for several minutes and recheck the

transmission oil level.

1 6

Figure 16. Transmission Oil Reservoir

Figure 17. Transmission Drain Plugs

Advertising