Stanton S-650 MK II - Manual (Page 6)

NAMES AND FUNCTIONS
(10)Pitch Slider
Use the slider to adjust the CD pitch. Slide up to decrease the pitch, down to increase the pitch.
(11)JOG (Jog Dial)
During PLAY, the jog dial is used temporarily bending the pitch (pitch bend). When CD is paused, the jog dial is used
for frame search each segment of the dial represents a frame. Frame search is mostly used to set an accurate cue
point.
(12)B. SKIP
Use these buttons to go back to the beginning of the current track or select a previous track for playing.
(13)CUE Indicator
When in CUE mode, the CUE indicator lights.
(14)CUE (Cue Button)
Pressing the CUE button during play provides a return to the position at which play was started. If PAUSE is used
before CUE or a CUE POINT was set, that will become the cue point. Alternately pressing the Play button and the
CUE button allows the CD to be played from the same position any number of times. The CUE LED will light up from
the time the CUE button is pressed until the CD has reset to the position at which play was started. Steady lighting of
this LED indications the ready condition. The CUE button can be held down to play a CD. When you release the CUE
button it instantly returns to the CUE POINT.
(15)KEY
This button activates the KEY Correction function. This function will allow you to make adjustment to a track speed
using the pitch control without altering a track perceived tonal pitch. When KEY is on, Pitch LED is flashing; and LED
is off when KEY is off.
(16)PLAY Indicator
The PLAY indicator lights during play mode.
(17)PLAY/PAUSE Button
Use the button to start playback. Press once to start playback, once again to set the pause mode, and once more to
resume playback.
(18)F. SKIP
Use these buttons to skip to the next CD track.
(19)IN R.CUE
This allows you to set the cue point without stopping the play back. This button also sets the beginning of a seamless
loop.
(20)OUT EXIT
This button is used to set the end point of a loop. Once the end point is set, the player automatically start looping.
Press this button again to exit the loop.
(21)PITCH (Pitch Button)
Press PITCH button to switch on/off pitch.; hold the PITCH button down for more than 0.6 sec to switch pitch in +/-8%
/ +/-12% / +/-16%.
(22)CONTROL CONNECTOR
Connect this connector to the REMOTE connector on the main unit using the included control cord
(23)FADER START CONNECTOR
Via the Control socket, the respective CD-player can be remotely controlled. If you are using a mixer with fader start-
function connect the player with the Control Out-socket. Please note that these sockets must never be connected with
any voltage.
5
22 23 22 23
CONNECT
TO
MAIN UNIT
1
CONNECT
TO
MAIN UNIT
2
CONTROL
2
CONTROL
1