Socket Mobile E500 - Manual (Page 11)

STEP 2: Insert Go Wi-Fi! or Turn on WLAN Radio
Insert Socket Go Wi-Fi! E300/E500 into the card
slot, or turn on the WLAN radio.
If using Socket Go Wi-Fi! E300/E500, make sure the
card is positioned correctly in the slot. Do not use
excessive force, or damage may occur.
If using a WLAN radio built into your Pocket PC,
refer to your Pocket PC manual for instructions.
Go Wi-Fi! Status Indicator LEDs
E300 Link LED
LED Behavior Meaning
Off Radio disabled/cannot transmit.
Slow flash Radio on, not connected.
On Connected
E500 LEDs
LED Type LED Behavior Meaning
Off Radio disabled/cannot transmit.
Flashing Radio on, using Power Save Mode
Power
Green
On Radio on, not using Power Save Mode
Off Radio disabled/cannot transmit.
Slow flash Radio on, no data traffic.
Activity
Amber
Rapid flash
Connected. Faster flash denotes
greater network activity.
Note: To remove the SD card from your Pocket PC, first press the card into
the slot. A spring mechanism will push the card out. Do not remove the
card by simply pulling it, or damage may occur.
CHAPTER 2: OPEN OR WEP-ENABLED NETWORKS 11