Summit SPW1200P - Manual (Page 19)

18
Check the following before calling for service.
Washer does not operate:
• Check if unit is plugged in. The plug may have come loose.
• Check if the electrical wall receptacle is of proper voltage.
• Check if the circuit breaker needs to be reset or if the fuse needs to be replaced.
• Check if the washer is overloaded: load may need to be re-balanced and clothes
may need to be redistributed.
• Check if the door is open. You may have to close the door properly.
• The washer pauses in some cycles. This is normal in heavy and normal cycle,
which has short soak period where your clothes are being soaked for very short
period of time. You will not hear washer operate for a short period of time. When
the soak time is over, it will start automatically.
• Check if option selections are set properly. You may have to adjust proper setting.
(refer to "Operation" section)
• Check if you have selected "Delay Start" option. You may have to turn that option
off and restart.
• Check the Power "On/Off" button to see if it is on "OFF" position. You may have
to press the button to set it on "ON" position.
• Check if the “Start/Pause” button is on “Pause” mode. Press this button to start the
wash process.
Troubleshooting