Sony TA-FB920R - Manual (Page 5)

Getting Started
5 GB
Ç L
R
PHONO
IN
З
з OUTPUT
LINE
L
R
INPUT
LINE
TAPE1/DAT
L
R
REC OUT IN
Tape deck, DAT deck, or MD deck
Use the configuration above to connect the OUTPUT and
INPUT jacks of:
—a tape deck or DAT deck to the TAPE1/DAT jacks.
—a tape deck or MD deck to the TAPE2/MD jacks.
Turntable
Tape deck Amplifier
Amplifier Turntable
Note
To prevent hum, connect the earth lead to SIGNAL GND ( y)
on the amplifier.
TV or video deck
Ç L
R
L
R
OUTPUT
LINE
AUX
IN
Amplifier TV or video deck
EON CONTROL
Amplifier Tuner
Ç
EON CONTROL
IN
EON CONTROL
OUT
If your tuner is equipped with an EON CONTROL OUT
terminal, connect it to the EON CONTROL IN terminal on
the amplifier to allow use of the EON (Enhanced Other
Networks) function of the RDS (Radio Data System) (see
page 8).
(+)
(–)
(+)
(–)
Speaker System Hookups
Overview
Here you learn how to connect speakers to the
amplifier. You can connect two pairs of speakers,
SPEAKERS A and B.
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
Twist the stripped ends of the cord about 15mm. Be sure to
match the speaker cord to the appropriate terminal on the
components: + to + and – to –. If the cords are reversed, the
sound will be distorted and will lack bass.
Hookups
SPEAKERS A SPEAKERS B
SPEAKERS
EON CONTROL
R
B
A
L + + – –
R L + + – –
TAPE1/DAT
L
REC OUT IN
IMPEDANCE USE 4–16 Ω A+B USE 8–16 Ω
BI WIRE USE 4–16 Ω
IN
R
L
R
TAPE2/MD REC OUT IN AUX IN CD IN TUNER IN
L
R
PHONO IN SIGNAL GND y
]
}
]
}