Sony HT-DDW880 - Manual (Page 59)

59 GB
E:\SEM_Janet\Year2006\Revision_Data\Revision3_HT-
DDW880\J9060043_2662263321DDW880_GB\2662263321\GB05AMP_HT-DDW880-CEL.fm masterpage: Right
HT-DDW880
2-662-263-32 (2)
T
uner O
p
e
ratio
ns
6
Press control button V/v
repeatedly to select “NAME IN”.
7
Press the control button or
control button
b to enter the
parameter.
The cursor flashes and you can select a
character. Follow the procedure given in
“To create an index name” below.
To return to the previous display
Press control button B.
To create an index name
1 Use control button V/v/B/b to create an
index name.
Press control button
V/v to select a
character, then press control button B/b to
move the cursor to the next position.
If you made a mistake
Press control button B/b until the character
you want to change flashes, then press
control button
V/v to select the correct
character.
Tip
You can select the character type as follows by
pressing control button
V/v.
Alphabet (upper case) t Numbers t Symbols
2 Press the control button.
The entered name is registered.
Note (Models of area code CEL, CEK
only)
When you name an RDS station and tune in that
station, the Program Service name appears instead
of the name you entered. (You cannot change the
Program Service name. The name you entered will
be overwritten by the Program Service name.)
Using the Radio Data
System (RDS)
(Models of area code CEL, CEK
only)
This receiver also allows you to use RDS
(Radio Data System), which enables radio
stations to send additional information along
with the regular program signal. You can
display RDS information.
Notes
• RDS is operable only for FM stations.
• Not all FM stations provide RDS service, nor do
they provide the same type of services. If you are
not familiar with the RDS services in your area,
check with your local radio stations for details.
Simply select a station on the FM
band using direct tuning (page 55),
automatic tuning (page 55), or
preset tuning (page 58).
When you tune in a station that provides RDS
services, “RDS” lights up and the program
service name appears on the display.
Note
RDS may not work properly if the station you tuned
to is not transmitting the RDS signal properly or if
the signal strength is weak.
Receiving RDS broadcasts
GB01COV_HT-DDW880-CEL.book Page 59 Wednesday, January 18, 2006 9:10 AM