Sole Control Remotes TT8 - Manual (Page 22)

TT8 -21-
Before contacting your dealer or SOLE service for aid, please review the following information. It
may save you both time and expense. This list includes common problems that may not be
covered under the treadmill s warranty.
PROBLEM SOLUTION/CAUSE
Display does not light The Safety tether cord not in position.
Circuit breaker on front grill tripped or power switch off. Push
circuit breaker in until it locks.
Plug is disconnected. Make sure plug is firmly pushed into AC
household wall outlet.
Household circuit breaker may be tripped.
Treadmill defect. Contact your SOLE dealer.
Treadbelt does not stay centered
Treadmill belt hesitates when walked/run on A user may be walking while favoring or putting more weight on
either the left or right foot. If this walking pattern is natural, track
the belt slightly off-center to the side opposite from the belt
movement. See General Maintenance section on Treadbelt
Tension. Adjust as necessary.
Motor is not responsive / Display is lit If the start button is pressed and the console is functioning, the
time display should be counting. If there is an error message
showing LS (low speed) try re-calibrating the treadmill (see
calibration procedure below).
Treadmill will only achieve approximately
7 mph but shows higher speed on display This indicates motor should be receiving power to
operate. Low AC voltage to treadmill. Do not use an extension
cord. If an extension cord is required it should be as short as
possible and heavy duty 14 gauge minimum. Low household
voltage. Contact an electrician or your SOLE dealer. A minimum
of 110 volt AC, 15 amp is required.
Treadbelt stops instantly (it should move High belt/deck friction. See General Maintenance
about a foot or so) when tether cord is section on lubrication.
pulled while standing on the unit
Treadmill trips on board 15 amp circuit Possible High belt/deck friction. See General Maintenance
Service Checklist - Diagnosis Guide