Southbend SB1017 - Manual (Page 17)

For Machines Mfg. Since 8/09 Model SB1017
-15-
P R E P A R A T I O N
Figure 15. Installing belt.
Figure 17. Pulley cover knob.
11. Pivot the motor assembly upward, then place
the belt over the gearbox and motor pulleys,
as shown in Figure 15.
12. Install the pulley cover (Figure 16) with two
M6-1 x 12 hex bolts, three 6mm flat washers,
and the South Bend cast aluminum knob
(see Figure 17).
13. Slide the vise handwheel onto the leadscrew
and tighten the set screw shown in Figure
18. Thread the handle into the handwheel
and tighten it.
Motor Pulley
Gearbox
Pulley
Motor
Assembly
Knob Location
Figure 16. Pulley cover.
Hex Bolts
Belt
Cover
Figure 18. Vise handwheel.
Set Screw
Handwheel
Handle
Leadscrew