SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 222)

Command Line Interface
7-52
• When 802.1x is supported, the access point supports
802.1x authentication only for clients initiating the 802.1x
authentication process (i.e., the access point does NOT
initiate 802.1x authentication). For stations initiating 802.1x,
only those stations successfully authenticated are allowed
to access the network. For those stations not initiating
802.1x, access to the network is allowed after successful
802.11 association.
• When 802.1x is required, the access point enforces 802.1x
authentication for all 802.11 associated stations. If 802.1x
authentication is not initiated by the station, the access point
will initiate authentication. Only those stations successfully
authenticated with 802.1x are allowed to access the
network.
• 802.1x does not apply to the 10/100Base-TX port.
Example
802.1x broadcast-key-refresh-rate
This command sets the interval at which the broadcast keys are
refreshed for stations using 802.1x dynamic keying.
Syntax
802.1x broadcast-key-refresh-rate <rate>
rate - The interval at which the access point rotates broadcast
keys. (Range: 0 - 1440 minutes)
Default Setting
0 (Disabled)
Command Mode
Global Configuration
AP(config)#802.1x supported
AP(config)#