Siemens CCIC1410 - Manual (Page 18)

Installation
18
Siemens Building Technologies
Fire Safety & Security Products 05.2009
7 Installation
7.1 Network setup
This section explains how to configure the network camera for Internet connection.
1.
If you have external devices such as sensors and alarms, connect them to the
general I/O terminal block.
2. Connect the camera to a switch/hub using an Ethernet cable. Use a Category
5 cross cable when the network camera is directly connected to a PC.
3. Connect the supplied power adapter from the network camera to a power
outlet.
4 3 1 2
There are several ways to set up the network camera via the Internet:
z Set up the network camera behind a router.
z Utilize a static IP.
z Use PPPoE.