Siemens CCIC1410 - Manual (Page 90)

Upgrade firmware
90
Siemens Building Technologies
Fire Safety & Security Products 05.2009
11 Upgrade firmware
This feature allows you to upgrade the firmware on your network camera. It takes
about five minutes to complete the process.
WARNING
Do not power off the network camera during the upgrade process and ensure
that the PC running the upgrade software (Installation Wizard / Web Browser) is
running stable. Otherwise the camera will be rendered defective (out-of-
warranty).
There are two ways to upgrade the firmware:
z Using the CCIC1410 Homepage
z Using the CCIC1410 Installation Wizard
11.1 Using the CCIC1410 Homepage
1. Download a new firmware file from SIEMENS website:
http://www.siemens.com/ip-cameras . The file is in pkg file format.
2. Open the CCIC1410 Homepage (see chapter 9.1).
3. Choose the Configuration menu.
4. On the left hand side, choose the menu item Maintenance.
5. In the Upgrade firmware section, click Browse and select the correct
firmware file.
6. Click Upgrade.
Î The network camera starts to upgrade and will reboot automatically when
the upgrade is complete.
Î The message “Reboot system now!! This connection will close”
indicates that the upgrade was successful.
7. Re-access the network camera.
11.2 Using the CCIC1410 Installation Wizard
NOTE
The CCIC1410 Installation Wizard allows you to upgrade several devices (of the same model) at the
same time. If you select different models, then the Firmware Upgrade button will be disabled.
1. Select one device or several devices in the device list on which you want to
upgrade the firmware (see chapter 8.3.1: Select a device for the
configuration).
2. Click the Firmware Upgrade button on the left side.
Î The following window appears: