SOYO SY-K7VEMPRO V1.0 - Manual (Page 10)

SY-K7VEMPRO V1.0 Quick Start Guide
10
Har
dw
ar
e
Install
atio
n
the CPU fan pins, get their revolution information and send it to the BIOS.
(2) Auto Power Off System: If the BIOS gets the information of CPU fan revolution, it goes on working
normally. If not, it will inform the system and have the power supply disconnected
immediately. Thus, the CPU is protected from over heating.
Note: The following must be observed to secure the normal functioning of “Fan-Off Control”:
1. CPU fan with sensor pins must be used.
2. CPU fans approved by AMD are strongly recommended.
3. The “HOT KEY” function is provided for the CPU fans without sensor pins, to avoid the power off.
Users may press the “Insert” key to jump over the “Power Off” mode; go to the BIOS and
disable “FOC”. Now system can be booted normally.
4. The power connector of the CPU fan must be connected to the specified “CPU Fan Connector” on
the motherboard to secure the normal functioning of the system.
We provide the following User-Friendly protection features:
1.Fan-Off Control : The motherboard detects the status of the CPU fan and protects the CPU by
automatically disconnecting the power supply. The default value of this function is Enable.
After booting up, the user may disable it.
2.CPU Socket Sticker : Users will find a sticker on the CPU socket, which reminds them of the
correct usage of the K7 CPU.
3. Heat Dissipation Paste: Heat Dissipation Paste is included for all Socket-A motherboards, to
enhance the heat dissipation capability.
Furthermore, we strongly recommend our users to enable the function of H/W monitoring in the BIOS.
This function, together with the FOC, provides the total protection to the CPU and allows it to maximize its
performance.
Step 2. CPU FSB Setting (JP3)
Refer to the following table:
CPU FSB Setting JP3
200MHz (Default) Short Pin2-3
266MHz Short Pin1-2
1 2 3
1 2 3