Southwing SH505 - Manual (Page 6)

6
your phone redial the last number
called.
Battery Level Indicator
You can check the battery level at any
time. With the Headset switched on, if
you press the Push4
TM Button 4 times,
you will repeatedly hear a battery level
indication:
· 4 tones for a remaining talk-time over
4 hours.
· 3 tones for a remaining talk-time
around 3 hours.
· 2 tones for a remaining talk-time
around 2 hours.
· 1 tone for a remaining talk-time
between ten minutes and approximate-
ly 1 hour and a half.
· A warning tone (high-low-high) will
sound when remaining talk-time falls
below ten minutes.
Pressing the button once more, you
will return to normal mode.
Automatic call pick up
If you wish to have all of your calls
accepted automatically (without any
button presses), you can enable the
automatic call pick up mode. To acti-
vate this mode, press the Push4
TM
Button 5 times on the Headset when it
is not in an active call. When you
receive an incoming call, your headset
will automatically answer the call after
2 seconds. To turn off the automatic
call pick up, just follow the same
steps.
Selecting Ring Tones
Your Headset is programmed with 12
different ring tones from which you
can choose.
With the Headset switched on, press
and hold both the Push4
TM and On/Off
Buttons for about 5 seconds to enter
the ring tone menu (you will also hear
the current ring tone). Then follow
these steps:
1. Touch the Vol+ or Vol- Sensors to
move up or down in the ring tone list.
2. Press briefly the Push4
TM Button
once to select your ring tone.
Please Note:
Some mobile phones will play their own ring
tones over the headset, replacing the user
selected ring tone from the Headset.
5. PUSH4 TM CALL*
Direct Call to your Push4 TM number (if
preconfigured)
Your Headset can be configured with a
specific Push4
TM call function. With the
Headset on, press and hold the
Push4
TM Button [2] for 1 second to call
directly the configured number or
phone service.
Configuring the Push4 TM button with your
favourite number
In some cases, you can use this
function as your favourite number. To
do so, you will first need to save your
favourite number on the Headset.
This can only be done when you have
received a call (A) from this same num-
ber into your Headset (not made
through a hidden call). Once this
received call has ended (B), press and
hold both On/Off [3] and Push4
TM [2]
buttons for 3 seconds, until you hear a
series of 3 tones. The number from the
last received call will be stored. (C)
Now you can make a direct call to this
number at any time just by pressing
and holding the Push4
TM Button [2] for
1 second.
* The features marked with asterisk are only possible with Bluetooth phones supporting the Bluetooth ® Hands-free profile.
Today, most Bluetooth phones support this profile.