Southbend HDG-24-M - Manual (Page 8)

S
PECIFICATIONS H EAVY D UTY C OUNTERLINE
P AGE 8 O WNER ’ S M ANUAL 1182845 REV 8
SPEC
IFICATIONS
CONSTRUCTION OF CHARBROILER MODELS
The front, top-rail sides, and 5" riser are all stainless steel. The rear and bottom panels are aluminized
steel. The reinforced double-wall sides are fully insulated.
Each 6" section has a gas valve for independent control of flame. Each burner is covered by a stainless
steel radiant or by a layer of ceramic briquettes.
The heavy cast iron grids have wide-branding (1/4") on one side and narrow branding (1/8" with grease
channel) on the other side. The tilt of each grid can be adjusted. Chrome-plated grids can be ordered for
cooking fish.
Figure 4
Front View
Top View
Side View
24.4"
Width (see table below)
3.9"
2.0"
2.8"
6.3"
11.0"
9.0"
15.3"
CONSTRUCTION OF OPEN TOP MODELS
The front, top-rail sides, and 5" riser are all stainless steel. The rear and bottom panels are aluminized
steel. The reinforced double-wall sides are fully insulated.
Each burner has its own gas valve, and is covered by a heavy cast iron grate.
Step-up models have elevated rear burners.
DIMENSIONS OF OPEN TOP MODELS
Model Width Number and Size of Burners Total BTU
HDO-12 12.25" 2 @ 26,000 52,000
HDO-24 & HDO-24SU 24.5" 4 @ 26,000 104,000
HDO-36 & HDO-36SU 36.625" 6 @ 26,000 156,000