Sierra Wireless RAVEN IDEN 20070914 - Manual (Page 9)

Raven iDEN
9 20070914
b. To see what you are typing as you type it, you will
need to turn on the echo and verbose mode. Type
ATE1V1 and press Enter.
c. If you get a reply of “OK”, then you entered the
command successfully. If you get a reply of “0” or
“ERROR”, try entering the command again.
5. Enter the Master Reset Command for
iDEN
a. Type AT*PROVISION=000000, 0123456789
b. The Raven should respond with: “Master Reset
Succeeded”. With any other response, contact TELUS
to check the account status.
c. Press the reset button on the Raven.
The Raven should now register on the network.
Hardware Installation
Your Raven should be mounted in a position that allows easy
access for the cables so they are not bent, constricted, in close
proximity to high amperage, or exposed to extreme tempera‐
tures. The LEDs on the front panel should be visible for ease of
operational verification. You should ensure that there is
adequate airflow around the modem but that it is kept free
from direct exposure to the elements, such as sun, rain, dust,
etc.
In a mobile location, such as a car or truck, ensure the location
is secure both against abrupt movements of the vehicle and
from other items coming into contact with the modem.
Caution: The Raven is in a hardened case and designed for use in
industrial and extreme environments. However, unless you are using
cables expressly designed for such environments, they can fail if
exposed to the same conditions the Raven can withstand.