Samsung ML-1651N - Manual (Page 151)

Selecting Print Settings
CONFIG
• Power Save determines the length of time the printer waits
after a job is printed before it goes to a reduced power state. If
the printer is used frequently, select OFF which keeps the
printer ready to print with the minimum warm-up time. This
uses more electricity to keep the printer warm and ready to
print.
• Econo Mode determines the toner quantity the printer should
use when printing. If set to ON, the printer conserves toner
when printing. The default value is OFF, which provides 100%
usage.
• Auto Continue determines what action the printer should take
when a manual feed print job is sent to the printer and there is
no paper in the Multi-Purpose Tray. If set to ON, the printer will
pick up the paper from the standard Tray 1 or optional Tray 2
after fifteen seconds. Otherwise, the printer will wait for you to
load paper in the Multi-Purpose Tray.
• Jam Recovery determines what action the printer should take
when a paper jam occurs. When set to OFF, the printer does
not reprint a page that has jammed. When set to ON, the
printer keeps the image in memory for a printed page until the
printer signals that the page has successfully printed. The
printer reprints all jammed pages.
JOB
• Timeout determines the amount of time (in seconds) the
printer will wait before printing the last page of a print job that
does not end with a command to print the page or a formfeed
character. Valid range is 0 to 300 seconds.
• Paper Type provides the printer with information about the
type of paper to be used for a print job. For the best result, set
this to the paper type you loaded in the paper tray in the
printer. When using the plain paper, set this to Default.
• SRT Mode makes the printer optimize the print quality to 1200
dpi image quality.
D.4 P
RINTING FROM
DOS A
PPLICATIONS