Southbend P36-CM-PT - Manual (Page 10)

O PERATION I NFRARED C HEESE M ELTER
P AGE 10 OF 24 O WNER ’ S M ANUAL 1186531 REV 2 (09/11)
2. Turn on the gas supply to the cheese melter (if not already on).
3. Light the pilots.
To light the pilots on a cheese melter WITH the flame failure option, do the following:
1. Turn the control valves on the front of the cheese melter to OFF.
2. Turn on the gas supply to the cheese melter (if not already on).
3. Turn one of the burner control knobs to the PILOT position and push the knob inward and hold it in place. While
continuing to hold the knob in, light the corresponding pilot and allow it to burn for 30 to 45 seconds. Release the
knob and check that the pilot remains lit. Repeat this step for the remaining burner control knobs and pilots.
S
HUTDOWN OF
C
HEESE
M
ELTER
To place the cheese melter in a standby state (ready for use), turn the burner control valves to OFF (or to PILOT on
units with the flame-failure option). The pilots will remain lit.
To completely shut down the cheese melter for an extended period (or prior to disconnecting the gas supply), turn the
burner control valves to OFF, then turn off the manual shutoff valves of all gas supply connections. (This will
extinguish all pilots.)