Southbend P36-CM-PT - Manual (Page 15)

I NFRARED C HEESE M ELTER I NSTALLATION
O WNER ’ S M ANUAL 1186531 REV 2 (09/11) P AGE 15 OF 24
S TEP 2 B : M OUNT ON W ALL
The cheese melter is installed by first attaching a mounting bracket to the wall, then attaching the cheese melter to the
bracket.
1. Attach the wall-mount assembly to the wall using the six 1/4" x 2" lag screws and six washers provided (see
Figure 5). Screw through frame and into wall studs since the cheese melter weighs as much as 265 pounds (120
kilograms).
2. Check that the wall-mount is level (both side-to-side and front-to-back).
Figure 5
Installation of Wall Bracket for Cheese Melter
3. It may be more convenient to prepare the gas supply line before the cheese melter is mounted on the wall
bracket. If so, install the supply line and connector now (but do not yet attach it to the cheese melter).
4. Lift the cheese melter (using two people is recommended) and hook the cheese-melter-hook over the top of the
front of the wall bracket. If necessary, move the cheese melter left or right so that the holes in the top of the
cheese-melter-hook line-up with the holes in the wall bracket, then secure the cheese-melter-hook to the wall-
mount bracket using three sheet-metal screws.
5. Secure the bottom of the cheese melter to the wall-mount bracket with the four provided 1/4" self-tap screws. The
holes are accessible from the opening in the bottom of the wall-mount unit.
6. Go on to Step 3.