Schumacher DieHard 00-99-000867-0109 - Manual (Page 4)

• 2 •
JUMP STARTER/DC POWER SOURCE FEATURES 2.
JUMP-STARTING A vEHICLE 3.
Warning: Failure to follow instructions may cause damage or an explosion.
Read the entire instruction manual before use.
turn the ignition
3.1 OFF before making cable connections.
Use in a well-ventilated area. 3.2
Keep clear of fan blades, belts, pulleys and other parts that may cause 3.3
injury.
Place the Jump Starter on a flat, stable surface near the vehicle battery
3.4
and away from moving engine parts.
make sure the rotary power switch on the front panel is in the O (OFF)
3.5
position until clamps are connected to the vehicle battery. If plugged into a
110v aC wall outlet, disconnect.
to prevent sparking, nEvER allow clamps to touch together or to contact
3.6
the same piece of metal.
Clamp the red clamp (+) to the positive terminal of the battery. (For a
3.7
negative grounded system.)*
Clamp the black clamp (-) to an unpainted and unmoving part of the chas-
3.8
sis or engine block. the 3-digit display will show the voltage of the battery.
Do not connect the clamp to the carburetor, fuel lines, or sheet-metal body
parts. Connect to a heavy gauge metal part of the frame or engine block.
If you have connected the clamps backwards, an audio alarm will sound.
3.9
DO nOt turn your jump starter on. this could cause serious damage.
Reverse the connections and the audio alarm will stop.
1
2
3
4
5
6
7
12v DC Power Outlet 1.
ON/OFF Power Switch 2.
Digital Display 3.
Display Select Push Button 4.
Switch
Replaceable Jaw Battery
5.
Clamps
Rubber Base
6.
Internal Battery Charger 7.
Outlet (not shown)