Sony DAV-S880 - Manual (Page 23)

Getting Star
ted
23 GB
DAV-S880 4-241-069-11(1)
IN IN OUT OUT OUT
VIDEO
OUT
R
VIDEO
IN
AUDIO
OUT
AUDIO
IN
L
VIDEO
OUT
R
AUDIO
OUT
L OUTPUT
VIDEO
IN
INPUT
OPTICAL
INTERLACE
SELECTABLE
SCAN SELECT
SPEAKER VIDEO 1
VIDEO 2
COMPONENT VIDEO OUT
MONITOR
OUT
COMPONENT
VIDEO OUT
FRONT
R
FRONT
L
R E A R
R
R E A R
L
CENTER WOOFER
COAXIAL
AUDIO OUT
L R L R
L R
VIDEO OUT VIDEO IN
OPTICAL
DIGITAL
IN
AUDIO IN
AUDIO IN VIDEO IN Y P B /C B P R /C R
AM
FM
75 Ω V I D E O
S VIDEO (DVD ONLY)
If you connect a digital satellite receiver with the OPTICAL jack
The digital satellite receiver can be connected to the OPTICAL jack instead of the VIDEO IN
and AUDIO IN L/R jacks of the system.
The system can accept both the digital and analog signals. Digital signals have priority over
analog signals. If the digital signal ceases, the analog signal will be processed after 2 seconds.
If you connect a digital satellite receiver without the OPTICAL jack
Connect the digital satellite receiver to the VIDEO IN and AUDIO IN L/R jacks only of the
system.
Setup for the system (for Asian and Australian models)
Setup is necessary for the system, depending on the TV monitor to be connected.
The initial setting for Asian models is NTSC but Australian models is PAL.
If the color system of the TV is PAL*
To set the system to PAL, turn on the system by pressing 1 (power) on the remote while
pressing X (pause) button on the system. You need to hold the X button until DAV-S880
appears on the display. To reset to NTSC, turn off the system and then turn on again using the
remote while pressing the X button on the system.
* If the color system of the TV is NTSC, do the same operation above to set the system to
NTSC.
Connecting the AC Power Cord (mains lead)
Before connecting the AC power cord (mains lead) of this system to a wall outlet (mains),
connect the speakers to the system (see page 17).
Connect the AC power cord (mains lead) of your TV/video components to a wall outlet (mains).
VCR Digital satellite receiver TV monitor