Sony DAV-S880 - Manual (Page 69)

Settings and Adjustments
69 GB
DAV-S880 4-241-069-11(1)
Settings for the Speakers
(SPEAKER SETUP)
To obtain the best possible surround sound,
set the size of the speakers you have
connected and their distance from your
listening position. Then use the test tone to
adjust the volume and the balance of the
speakers to the same level.
Select “SPEAKER SETUP” in the setup
display. For details, see “Using the Setup
Display” (page 64).
The default settings are underlined.
To return to the default setting
Select the item, then press CLEAR.
xSIZE
When you do not connect center or rear
speakers, or move the rear speakers, set the
parameters for CENTER and REAR. Since
the front speaker and subwoofer settings are
fixed, you cannot change them. The default
settings are underlined.
• FRONT
— YES
• CENTER
— YES: Normally select this.
— NONE: Select this if no center speaker
is used.
• REAR
— BEHIND (LOW), BEHIND (HIGH),
SIDE (LOW), SIDE (HIGH): Specify
the position and height to implement
the Digital Cinema Surround modes.
— NONE: Select this if no rear speaker is
used.
• SUBWOOFER
— YES
SPEAKER SETUP
DISTANCE:
TEST TONE:
SIZE:
BALANCE:
LEVEL:
Notes
• When you select an item, the sound cuts off for a
moment.
• Depending on the settings of other speakers, the
subwoofer may output excessive sound.
Specifying the rear speaker position
and height
If you select anything other than “NONE” in
“REAR,” specify the position and height of
the rear speakers. The default setting is
underlined.
BEHIND (LOW)
BEHIND (HIGH)
SIDE (LOW)
SIDE (HIGH)
Select this if the rear
speakers are located in
section B and D.
Select this if the rear
speakers are located in
section B and C.
Select this if the rear
speakers are located in
section A and D.
Select this if the rear
speakers are located in
section A and C.
These parameters are not available when “REAR” is
set to “NONE.”
continued