SRS Labs CSD-07D - Manual (Page 9)

CSD-07D Operation
(see front panel image on page 4)
1. Input Signal Presence: Displays
signal presence and clip on corresponding
input channels. When the LEDs glow green on the
front panel, the corresponding channel is receiving a
signal > -44 dBFS at the input. If the LED is not
illuminated, a signal > -44 dBFS is not present. The
clip indicator LEDs will turn red at 0 dBFS.
* Note that if the signal indicator is not illuminated, it may simply indicate a transitory period where no
content is present in the source mix.
2. Sync Source Switch:
Determines the input source for the Sync signal.
When using the clock within the audio signal, choose
AES pair 1. When using an external clock source,
plug the clock input (AES 11) into the External Sync
XLR in on the back of the unit and select AES 11
clock. If there is no valid sync on the selected source,
the corresponding LED will flash.
3. Center / Phantom Switch: Determines whether the unit outputs a discreet center
channel or mixes center into left and right. If a center
channel speaker is not available, select the
“Phantom” option. If monitoring with a discreet center,
select the “Center” option. This function works in
mono monitoring as well.
4. Sample Rate Indicator:
Displays the sample rate of the clock source selected
above. If there is no valid sample rate, no LED will be
illuminated. If the sample rate is 44.1kHz or 48kHz,
the corresponding LED will be illuminated.
5. Monitor Mode:
Determines how the decoder monitors the incoming
signal. The orange LEDs next to the modes will
indicate mode status (See Page 11 for Button
Function diagram). The five modes are as follows:
CS Cinema – Lt/Rt LED Solid:
Press the Monitor Mode
button until it cycles to Lt/Rt.
Monitors the mix with Circle Surround Cinema
decoding. This is ideal for monitoring or extracting TV
and film content. Use the additional Lt/Rt Mode
selector (see below) to choose whether the output is
LCRS, Circle Surround Cinema or Circle Surround
Discrete compare.
Stereo – Stereo LED Solid:
Press the Monitor Mode button
until it cycles to Stereo .
8