Seagate CHEETAH 9 ST19101N/W/WC/WD/DC - Manual (Page 22)

20 Cheetah 9 Installation Guide, Rev. B
Initial setup information
The general information beginning on this page applies to all of
the Cheetah 9 drive models. After reading the general informa-
tion topics, refer to the appropriate drive-specific section listed
below for additional information about configuring and installing
your particular model.
Drive models Page
ST19101N 39
ST19101W/WD 43
ST19101WC/DC 48
General information
The following general information topics are discussed:
• SCSI ID jumpers
• Drive termination
• Terminator power
• Interface drivers and data path width notes
• Other applicable jumper options
• Providing adequate cooling
• Mounting the drive and connecting cables
1
• Formatting the drive
1 This mounting procedure does not apply to “WC” or “DC” model
drives. To mount a “WC” or “DC” drive, plug the drive into the
system’s single connector attachment (SCA) position on the
system’s back panel.