Sea Eagle Boats 325FC - Manual (Page 3)

3
Feed the 2 fabric beads in the bow of the 375fc FoldCat hull
through the 2 nylon slotted fittings under the aluminum step
bench as shown.
Stabilizer Underbars
The SE 375fc, has 4 aluminum stabilizer underbars - 2 short
and 2 long. The SE 325fc has 4 stabilizer bars all short.
From the bow of the FoldCat slide the short aluminum
underbars under the first and the second aluminum slats
between the fabric beads holding the slats along the length
of each pontoon.
Align the bow end of the stabilizer underbar against the
triangular marking on the bow of each pontoon as shown
below Please note, on the SE 325fc, the 2 short stabilizer
bars actually are closer to the aluminum board than shown
above and they should meet together under the center
aluminum board.
Similarly, slide the long stabilizer underbars from the stern
of the FoldCat under the rearmost, 2nd rearmost and the
3rd rearmost aluminum slats.
Align the stern ends of these underbars against the
triangular markings on each pontoon in the stern.
Also make sure that the long and the short underbars are
aligned properly along the length of the pontoon. On the SE
375fc, the aluminum underbars must nearly touch each
other (approximately towards the center of the pontoon)
between the 2nd aluminum slat from the bow and 3rd
rearmost slat as shown below. On the SE 325fc, the
aluminum underbars also meet each other but under the
aluminum center bench.
The frame of the FoldCat 325fc or 375fc is ready for inflation
and looks like this. Please note, on the SE 325fc there are
only 3 aluminum cross benches and no aluminum step
bench.
Inflation Instructions
The FoldCat 325fc & 375fc have Halkey-Roberts valves on
both pontoons.
The valve cap unscrews to
reveal the yellow valve stem.
When this stem is in the up
position as shown the valve
retains air. The valve should
be in this position to inflate
the boat.
STERN
STERN
STERN
SE 375fc
shown
SE 375fc
shown
SE 375fc
shown