Sea Eagle Boats 325FC - Manual (Page 8)

8
Insert the canopy
rods with
preassembled pins
into the raised oar
lock rod bases as
shown.
The center black
strap on the canopy
should be attached
to the sea tie on the
aluminum step rod
in the bow.
Attach the other two
black straps to the
two sea ties on the
last aluminum slat
in the stern as
shown.
Fully assembled canopy should look like this
Casting Bar
A) Installation for FoldCat 375fc
(1) Partially deflate both
pontoons and insert the
base arm of the casting
bar under the first slat
in the bow of the
FoldCat as shown.
Place the other end of
the base under the step
rod so that the step rod fits in the notch as shown in the
next picture.
(2) Now insert the
snaplock bracket at this
end as shown.
(3) Push the snaplock
bracket so that the pin
is snapped in position.
Attach the base to the
other side of the
FoldCat in the same
way.
(4) Now raise the other
ends in the vertical
position so that the
snaplock pin at the
elbow joint snaps in
place.
(5) Now attach the
upper part of the
casting bar to the raised
ends till the snaplock
button locks in place.
You may adjust the
height of the casting bar
to the position that is
comfortable to you.
B) Installation for FoldCat 325fc
Partially deflate both pontoons and insert the base arm of
the casting bar under the first slat in the bow of the
FoldCat.
Unlike the 375fc, on the 325fc do not attach
the other end of the base to the step rod and follow
steps (1), (4) & (5) only explained above for FoldCat
375fc.
The reason why the casting bar is not attached to
the step rod on a 325fc is because it will be too far from
the person standing on the first slat. Casting bar on the
325fc should look this this: