Silex technology Print/Scanner/Storage Wireless Server PRICOM C-6400W - Manual (Page 17)

2-6 PRICOM C-6400W
Users Manual CX2
Start in Infrastructure mode
- It is possible to put the PRICOM C-6400W into Infrastructure mode and connect to an access
point if the access point does not use WEP.
1. With the PRICOM C-6400W set to
factory default, verify the Link LED is
on after the connecting the AC adapter
to the PRICOM.
2. After holding the push switch for 15
seconds, release the switch.
3. After a few seconds, all of the LED’s
will light and then go out immediately.
4. After a few seconds, the Infra. LED will
light. Then if the PRICOM C-6400W
can connect to an access point, the
Link LED will light.
- If the Infra LED lights but Link LED does not, The PRICOM C-6400W cannot connect to an
access point. Check the following and Reboot the PRICOM C-6400W.
1. Does the access point require a WEP key?
2. Does access point use a security setting?
3. Is anything blocking the PRICOM C-6400W and the access point?
4. Are the PRICOM C-6400W and Access point close enough?