Samsung HL-P5067W - Manual (Page 12)

4
Press the … or † button to select the
Antenna connection, then press the
ENTER button.
• Air : “Air” antenna signal
Cable : “Cable” antenna signal
Air+Cable : “Air” and “Cable” antenna
signals
• If the CableCARD is inserted into
the“CableCARD” slot on the rear panel,
“Cable” and “Air+Cable” are not avail-
able.
When selecting Cable TV system:
Press the
… or † button to select
“Cable”, then press the ENTER button.
Press the
… or † button to select Analog
or Digital “STD”,"HRC" or "IRC" then
press the ENTER button.
• STD, HRC and IRC identify various
types of cable TV systems.
Contact your local cable company to
identify the type of cable system that
exists in your particular area.
At this point the signal source has been
selected. Proceed to “Storing Channels
in Memory”.
5
Press the √ button to select “Start”, then
press the ENTER button to start the auto
program. The TV begins memorizing all
available stations. Press the ENTER but-
ton at any time to interrupt the memoriza-
tion process.
Press the EXIT button to exit.
• The TV MUST be connected to an
antenna in order to receive digital TV
signals. Even if a particular channel is
deleted from the memory, you can
always tune to that channel directly by
using the number buttons on the remote
control.
Auto Program
Enter Return
Auto Program in progress
AIR Channel 44
Stop
Auto Program
Select the antennas to memorize
Air
Cable
Air+Cable
Move Enter Return
Input
Picture
Sound
Channel
Setup
Guide
Start
Start
Start
Auto Program
Move Enter Return
Input
Picture
Sound
Channel
Setup
Guide
Select the cable system.
Analog
Digital
STD
HRC ✔
IRC
STD ✔
HRC
IRC
Auto Program
Move Enter Return
Input
Picture
Sound
Channel
Setup
Guide
Start
Select the cable system.
Analog
Digital
STD ✔
HRC
IRC
STD ✔
HRC
IRC
Start
12
BP68-00429A-00Eng 11/10/04 3:18 PM Page 12