Sony DVP-NS601H - Manual (Page 23)

23 US
H
o
o
kups
8
Press ENTER.
The Setup Display for selecting the type
of jack used to connect your audio
component such as an amplifier
(receiver) appears.
9
Press X/x to select the type of jack
(if any) you are using to connect to
an audio component, then press
ENTER.
If you did not connect an audio
component, select “NO,” then go to step
13.
If you connected an audio component
using just an audio cord, select “YES:
LINE OUTPUT L/R (AUDIO),” then go
to step 13.
If you connected an audio component
using a digital coaxial or optical/HDMI
cord, select “YES: DIGITAL OUTPUT.”
10
Press X/x to select the type of
Dolby Digital signal you wish to
send to your audio component.
If your audio component has a Dolby
Digital decoder, select “DOLBY
DIGITAL.” Otherwise, select “D-PCM.”
11
Press ENTER.
“DTS” is selected.
12
Press X/x to select whether or
not you wish to send a DTS signal
to your audio component.
If your audio component has a DTS
decoder, select “ON.” Otherwise, select
“OFF.”
13
Press ENTER.
Quick Setup is finished. All connections
and setup operations are complete.
Note
When “PhotoTV HD” mode is activated (page 50),
the selection for “TV TYPE” is skipped.
Is this player connected to an amplifier
(receiver)? Select the type of jack you
are using.
LINE OUTPUT L/R(AUDIO)
DIGITAL OUTPUT
YES
NO
AUDIO SETUP
AUDIO DRC:
DIGITAL OUT:
DOLBY DIGITAL:
STANDARD
ON
DOWNMIX: DOLBY SURROUND
D-PCM
D-PCM
48kHz/96kHz PCM:
DTS:
DOLBY DIGITAL
AUDIO SETUP
AUDIO DRC:
DIGITAL OUT:
DOLBY DIGITAL:
STANDARD
ON
DOWNMIX: DOLBY SURROUND
D-PCM
OFF
48kHz/96kHz PCM:
DTS:
OFF
ON