Schneider Electric POWERLOGIC PWRSRV750 - Manual (Page 31)

63230-216-207/A3 Chapter 5—Setup
9/2002 Configuring the Power Server
27 © 2002 Schneider Electric All Rights Reserved
Configuring Your POWERLOGIC System While in setup mode, you can add devices to the POWERLOGIC System.
Serial connections for COM 3 and COM 4 of the Power Server are already
defined in the system. Do not delete these settings or define a new
communication connection for COM 3 or COM 4 ports.
To add devices to the Power Server, follow these steps.
1. Double click the PowerLogic Server icon on the desktop to launch
the application.
2. For user ID, enter: master
3. For password, enter: master, then click OK.
4. Double click the PowerLogic System Setup icon on the desktop to
launch the application.
5. For user ID, enter: master
6. For password, enter: master, then click OK once the POWERLOGIC
System Setup is started.
7. Select File > Offline to place the POWERLOGIC System offline.
8. Configure the system by defining the communication connections and
adding devices. To do this, select Setup > Communications and then
Setup > Devices/Routing.
NOTE: If you need help configuring the PowerLogic system, refer to the
online help file “Quick Starts” listed in the help contents. From the
PowerLogic System Setup utility, click Help > SMS-3000 Help > Quick
Starts > Quick Start: Serial Device Setup.
9. Depending on the type of Power Server you have and functions required,
perform setup procedures as needed for:
• Alarms
• Reports
• Waveforms
• Diagrams
Refer to the Power Server user’s guide 63230-216-217 for details.
10. After configuring the system, place the POWERLOGIC system back
online by selecting File > Online > System.
The Power Server has only one system, which is always open for editing.
It should always be left online except during configuration.
11. Close the POWERLOGIC System setup application.
12. Set the Power Server to run mode.
Refer to “Changing the Mode from Setup to Run Mode” on page 28.
CAUTION
POSSIBLE LOSS OF COMMUNICATIONS
Ensure that your POWERLOGIC system is online before exiting
POWERLOGIC System Setup.
Failure to do so will result in communication errors.