Schneider Electric POWERLOGIC PWRSRV750 - Manual (Page 43)

63230-216-207/A3 Appendix D—Integrating the Power Server into SMS
9/2002
39 © 2002 Schneider Electric All Rights Reserved
APPENDIX D—INTEGRATING THE POWER SERVER INTO SMS
This appendix provides instructions for using System Manager Software
(SMS) to set up a PC interface to communicate through the Power Server as
a gateway to the Power Server’s attached serial slave devices.
To communicate with SMS through the Power Server, follow these steps:
1. Launch SMS.
2. Open an existing system or create a new system.
3. Add a communication connection.
• For the communications connection name, type in a unique name for
your Power Server connection.
• For the communications driver, select “MODBUS/TCP driver.”
4. Enter the Power Server IP address in the communication connection
(MODBUS/TCP).
5. After defining the communications connection, add the serial daisy-
chained devices using the previously defined Power Server
communication connection.
For more details, refer to the SMS Help option in SMS by going to SMS >
Quick Start > Quick start MODBUS/TCP device setup.