Schneider Electric POWERLOGIC PWRSRV750 - Manual (Page 58)

Appendix G—POWERLOGIC System Display (SD700) Installation 63230-216-207/A3
Calibrating the Touch Screen 9/2002
© 2002 Schneider Electric All Rights Reserved 54
3. Connect the female end of the serial cable to the COM 2 serial port on
the Power Server (see Figure G–2). Tighten the captive screws on the
cable connector.
4. Connect the male end of the serial cable to the Touch Screen Serial
Output port on the system display. Tighten the captive screws on the
cable connector.
5. Locate the video cable supplied with the system display.
6. Connect one end of the video cable to the female Video input port on the
side of the system display. Tighten the captive screws on the cable
connector.
7. Connect the other end of the video cable to the VGA output port on the
Power Server (see Figure G–2). Tighten the captive screws on the cable
connector.
Figure G–2: Power Server connectors
CALIBRATING THE TOUCH SCREEN The first time you power up the system display, you should calibrate the
touch screen.
To calibrate the touch screen, do the following:
1. Ensure that the Power Server is running and that the Power Server
interface is visible on the monitor.
2. Touch the Maintenance tab.
3. On the Maintenance tab, touch the Calibration button.
4. Follow the on-screen instructions.
5. When calibration is complete, touch the screen in several places and
ensure that the pointer arrow accurately follows your touch. If it does not,
repeat the calibration procedure.
CARE AND CLEANING Occasionally clean the display panel with a soft cloth dampened with glass
cleaner. Spray cleaner on the cloth. Do not spray cleaner directly on the
touchscreen. Keep turning a fresh side of the cloth toward the screen surface
to avoid scratching it with accumulated grit. Allow the screen to air dry.
NOTE: Never use ammonia-based cleaners to clean the touchscreen. Do
not use paper products to clean the screen as they may scratch the surface.
COM2
VGA output port — connect
to the VIDEO input port on
the system display.
COM 2 serial port — connect to
the touch screen output port on
the system display.