SEH Computertechnik ISD300 - Manual (Page 5)

ISD300 User Manual
ISD300 User Manual
General Information
5
Safety Regulations
Before starting the initial operation procedure and during the
operation procedure of the ISD300, please read the following safety
regulations:
- The ISD300 may only be connected to the mains and to the
network by qualified personnel.
- Do not open the housing of the device. The ISD300 may only
be connected and operated if the housing is not opened and if
the ISD300 is in perfect condition. Do not put objects on top of
the housing.
-
The ISD300 must be placed on a solid surface with no
vibration. The device must not be operated in dusty places and
direct sunlight. Avoid contact with humidity or liquids. The
ISD300 may only be connected and operated if the installation
location meets the ambient conditions; see: Technical Data on
page 4.
- If the supplied power cord cannot be used in your country,
acquire an appropriate power cord that suits national
provisions. For more information, please consult your retailer.
-
Make sure that no-one steps on or stumbles over the cables.
-
The ISD300 must be connected to a socket with protective
contact.
-
Position the ISD300 in a way that guarantees that the socket
for the connection of the power cord is in the proximity of the
device and is easily accessible. Make sure that the device can
be separated easily from the network. A damaged power cord
must be replaced immediately. For more information, please
consult your retailer.
- Do not connect a telephone cable to the RJ-45 connector. The
RJ-45 connector may only be connected to SELV voltages. For
the connection to the RJ-45 connector only S/UTP cabling
(category 5 or better) may be used. The shielding must fit
flushly to the connector.
-
Use a certified USB Hi-Speed cable to connect the printer. A
list of certified cables may be found at www.usb.org !