Sony CDX-C7850R - Manual (Page 23)

23
SET UP
Changing the sound and
display settings
The following items can be set:
•Clock (page 7).
•CT (Clock Time) (page 20).
•D.Info (Dual Information)*
1 – to display the
clock and the play mode simultareously
(ON) or to display the information
alternately (OFF).
•Amber/Green – to change the illumination
colour to amber or green.
•Dimmer – to change the brightness of the
display.
— Select “Auto” to dim the display only
when you turn the interior lights on.
— Select “on” to dim the display.
— Select “off” to deactivate Dimmer.
•Contrast – to adjust the contrast if the
indications in the display are not
recognisable because of the unit’s installed
position.
•Beep – to turn the beep sounds on or off.
•RM (Rotary Commander) – to change the
operative direction of the controls of the
rotary commander.
— Select “norm” to use the rotary
commander in the factory-set position.
— Select “rev” when you mount the rotary
commander on the righthand side of the
steering column.
•L.out (Line output)* 2 (page 24)
•Loud (Loudness)* 1 – to enjoy bass and treble
even at low volumes. The bass and treble will
be reinforced.
•LPF (Low Pass Filter)* 1 (page 23)
•M.dspl (Motion Display) – to turn the motion
display to 1, 2, or off.
•A.Scrl (Auto Scroll)* 1 (pages 9, 25)
1
Press (SHIFT).
2
Press (3) (SET UP) repeatedly until the
desired item appears.
Each time you press (3) (SET UP), the item
changes as follows:
Clock n CT n D.Info* 1 n Amber/Green n
Dimmer n Contrast n Beep n RM n L.out* 2
n Loud* 1 n LPF* 1 n M.dspl n A.Scrl* 1
* 1 When the radio is off, or when no CD, or MD
is playing this item will not appear.
* 2 When the optional equalizer preamplifier is
not connected, this item will not appear.
Note
The displayed item will differ depending on
the source.
3
Press (5) (n) to select the desired
setting (Example: on or off).
For the “Contrast” setting, pressing
(5) (n) makes the contrast higher, and
pressing (2) (N) makes the contrast lower.
4
Press (SHIFT).
After the mode setting is complete, the
display returns to normal playback mode.
Adjusting the frequency of
the subwoofer(s)
To match the characteristics of the connected
subwoofer(s), you can cut out the unwanted
high and middle frequency signals entering
the subwoofer(s). By setting the cut-off
frequency, the subwoofer(s) will output only
low frequency signals for a clearer sound
image.
1
Press (SOURCE) to select a source (radio,
CD or MD).
2
Press (SHIFT), then press (3) (SET UP)
repeatedly until “LPF” appears.
3
Press (5) (n) or (2) (N) repeatedly to
select desired setting.
Each time you press (5) (n) or (2) (N),
the cut-off frequency in the display changes
as follows:
LPF off ˜ LPF 80 Hz ˜ LPF 120 Hz
4
Press (SHIFT).
When the frequency setting is complete, the
display returns to the normal playback
mode.