Sony DPS-V55M - Manual (Page 20)

20 GB
Precautions
On safety
• Should any liquid or solid object fall into the unit, unplug the
unit and have the unit checked by qualified personnel before
operating it any further.
On power sources
• Before operating the unit, be sure that the operating voltage of
your unit is identical with that of your local power supply.
• Unplug the unit from the wall outlet if it is not to be used for an
extended period of time. To disconnect the cord, pull it out by
grasping the plug. Never pull the cord itself.
• AC power cord must be changed only at the qualified service
shop.
On placement
• Place the unit in a location with adequate ventilation to prevent
heat build-up and prolong the life of its components.
• Do not place the unit near heat sources, or in a place subject to
direct sunlight, excessive dust or mechanical shock.
• Do not place anything on top of the cabinet which might block
the ventilation holes and cause malfunctions.
On cleaning the cabinet
• Clean the cabinet, panels and controls with a soft cloth lightly
moistened with a mild detergent solution. Do not use any type
of abrasive pad, scouring powder or solvent such as alcohol or
benzine.
On repacking
• Do not throw away the carton and the packing material. This
makes an ideal container when transporting the unit. When
shipping the unit, repack it as it was packed at the factory.
If you have any question or problem concerning your unit that is
not covered in this manual, please consult your nearest Sony
dealer.
When requesting repairs, all user program data (#201~400)
will be reverted to the original factory data settings.
Before requesting repairs, be sure to save your important data
using an external MIDI data filer, or by making written notes
of the parameter settings.
Specifications
A/D Converter
D/A Converter
Sampling
Frequency
Input (rear panel)
Input (front panel)
Output
MIDI Input/Output
Frequency Response
Signal–to–Noise
Ratio
Distortion
Effect Algorithms
Memory
Power Source
Power Consumption
Dimensions
Mass
Supplied accessories
Design and specifications subject to change without notice.
Jack type
PHONE
20 bit resolution
20 bit resolution
48 kHz
Jack: 5 pin DIN (IN x 1, OUT/THRU x 1)
OUT/THRU can be set to either OUT or THRU
20 Hz ~ 22 kHz (+0, –1 dB)
Greater than 93 dB
Less then 0.005% (1 kHz)
45 (4ch: 9, 2ch: 27, Mono-Pair: 9)
Preset 200 locations (numbers 001~200)
User 200 locations (numbers 201~400)
AC 230 V, 50/60 Hz
12 W (230 V)
482 x 88 x 290 mm (WxHxD not including
projections)
approx. 3.6 kg
Operating Instructions (1)
Effect Parameter Guide (1)
Preset Memory Catalog (1)
Jack type
PHONE
circuit type
unbalanced
input
impedance
More than
45 kilohms
reference
input level
–10 dBu
or +4 dBu
maximum
input level
+20 dBu
circuit type
unbalanced
load
impedance
less than 1
kilohm
maximum
output level
+10 dBu
or +20 dBu
reference
output level
–10 dBu
or +4 dBu
Jack type
XLR/
PHONE
circuit type
balanced
input
impedance
10 kilohms
reference
input level
–50 dBu
maximum
input level
+10 dBu
Additional Information