Sony DPS-V55M - Manual (Page 7)

7 GB
Names and Functions of Parts
Rear panel
1 LCD CONTRAST knob
Use to adjust the contrast of the display on the front
panel.
2 MIDI OUT/THRU terminal
For sending and/or relaying MIDI command signals
from the processor to other components. To switch
between OUT and THRU, see pages 17~18.
3 MIDI IN terminal
Input for MIDI command signals. Use a commercially
available MIDI cable to connect this terminal to another
component's MIDI OUT (or THRU) terminal.
4 OUTPUT jacks (1~4)
Standard output jacks for channels 1, 2, 3, and 4.
Connect to and amplifier or mixer (etc.).
Jacks are divided into two groups:
GROUP A (1 (L) and 2 (R))
GROUP B (3 (L) and 4 (R))
Output level selector
Use to set the output level of the OUTPUT jacks to
match the input level of the connected equipment.
You can select a +4 dBu or –10 dBu output level.
This setting effects all jacks (1, 2, 3, and 4).
5 INPUT jacks (1~4)
Standard input jacks for channels 1, 2, 3, and 4.
Connect to mixer, CD player, or keyboard (etc.).
Jacks are divided into two groups:
GROUP A (1 (L/MONO) and 2 (R))
GROUP B (3 (L/MONO) and 4 (R))
When inputting a monaural signal, use the 1 or 3
(MONO) jacks. The signal is sent to both of the
channels in the respective group.
Input level selector
Use to set the input level of the INPUT jacks to match
the output level of the connected equipment.
You can select a +4 dBu or –10 dBu input level.
This setting effects all jacks (1, 2, 3, and 4).
6 AC power cord
Connect to an AC power outlet.
2 3 4 5 1 6