Sony NHS-2000 - Manual (Page 15)

Using the RF Remote Commander Unit
13
Cable/Sat Page 2
1. WIDE MODE button. Cycles the main room television among three different
widescreen modes: Full, Zoom, Wide Zoom and then back to Full.
2. PAGE BACK button. Takes you to control page 1 of 2.
3. PAGE FORWARD button. Takes you to control page 1 of 2.
4. CABLE/SAT POWER button. Turns on and off your set-top box.
5. NUMERAL buttons. Select channels directly by number.
A. For one- or two-digit channels, touch the numeral buttons and
touch the ENTER button.
B. For three-digit disc numbers, touch the >10 button first, then the
three numeral buttons and the ENTER button.
6. >10 button. Push this before you select a three-digit channel number.
7. ENTER button. Accesses the channel you've selected with the NUMERAL buttons.
8. F1 button. Activates a custom function, if available, that may be programmed by your installer.
9. F2 button. Activates a custom function, if available, that may be programmed by your installer.
Recharging the RF Remote
Commander Unit.
The RF Remote Commander unit is powered by
an internal, rechargeable battery. When the "low
battery" on-screen icon appears in the LCD
window, recharge the battery by inserting into the
cradle, as shown. The cradle should be plugged
into a standard AC power outlet. You can
continue to operate the RF Remote Commander
unit, even as it recharges in the cradle.
Understanding system status.
The top right of the LCD window contains status information
This shows your current volume control setting as decibels
below full volume. (For example -20 dB is louder than -30 dB.)
RF communication between the unit and the base station
antenna is functioning properly.
RF communication between the unit and the base station
antenna is not functioning properly. There may be interference
or the transmission distance may be too great.
• Place the RF Remote Commander unit closer to the RF
antenna, located near the System Rack.
• Avoid interference by metal objects, such as a cabinets or
interference by other Radio Frequency sources.
• Move the RF Remote Commander unit one inch to the
left, right, up or down. Sometimes a small movement can
solve the problem.
Trouble has occurred. Contact your Sony installer.
The internal battery is being charged by the charger cradle.
Low battery.
• Charge the battery by placing the RF Remote
Commander unit on the charger cradle.