Sanyo DAS-204 User Manual
Page 4
9V
LINE
DC IN
TEL
–
+
Figure 1
Figure 2
Figure 3
4
5
BATTERY INSTALLATION
Your answering machine is equipped with a Battery Backup system. In the
event of a power failure, the battery backup will prevent the loss of new saved
messages as well as OGM 1 and OGM 2.
Please follow these simple instructions to install a 9-volt battery (not included).
Remove the
battery cover screw
Remove the
battery cover
Connect a 9-V battery
Replace the battery
cover and replace
the screw
in power failure
This battery stands 24 hours
Check your OGM after power failure
WARNING
OPEN
When you replace the battery
please pull line cord out
in po
wer
failu
re
This
batte
ry sta
nds 2
4 hou
rs
Chec
k you
r OG
M aft
er po
wer f
ailure
WAR
NING
O
P
E
N
Whe
n you
repl
ace t
he b
atter
y
pleas
e pu
ll line
cord
out
in power failure
This battery stands 24 hours
Check your OGM after power failure
WARNING
OPEN
When you replace the battery
please pull line cord out
IMPORTANT SAFETY INSTRUCTIONS
When using your answering system, basic safety precautions should always be
followed to reduce the risk of fire, electric shock and injury to persons, including
the following:
1.
Do not use this product near water, for example, near a bathtub, kitchen
sink, laundry tub, in a wet basement, or near a swimming pool.
2. Use only the batteries indicated in the manual. Do not dispose of batteries
in a fire. They may explode. Check with local codes for possible special
disposal instructions.
Save these instructions
INSTALLATION
1.
The DAS-204 includes a modular telephone line cord with a modular plug
at each end. Insert one plug into the LINE input jack on the unit, and the
other end into your household telephone jack (Figure 1). You may have to
unplug your telephone to do this.
2.
To use a phone in the same area of the DAS-204, simply plug the
telephone into the TEL input jack on the machine (Figure 2).
3.
Connect the AC Adapter (included-DC 9-V 300mA) to a standard electrical
outlet (120V AC) and plug the other end into the DC power input jack on
the unit (Figure 3).