Sanyo DAS-204 User Manual
Page 9
LED DISPLAY DESCRIPTION
LED Display
LED Status
Description
0-59
ON
Number of messages recorded
A1/A2
Flashing
OGM1/OGM2 not recorded
A1/A2
ON
OGM1/OGM2 recorded or played
An
ON
ANSWER-RECORD mode
Ao
ON
ANSWER-ONLY mode
On
ON
Answering Machine On
CL
ON/Flashing
Time played/Time setup is needed
––
ON/Flashing
Answering incoming call/CBT mode
Cc
ON
CBT code setup/display
Sc
ON
Remote security code setup/display
Lo
ON
Battery low or absent
Blank
OFF
Enter POWER-DOWN/DOWN mode
FuON
Memory fu
ll
PS
ON
Pause
ES
ON
All messages erased
00
ON
Memo message record/play
ER
ON
Memory failure
2R
ON
Two-way recording
=
ON/Flashing
Display/setup 1st digit of code
=
ON/Flashing
Display/setup 2nd digit of code
–
ON/Flashing
Display/setup 3rd digit of code
En
ON
English version
Fr
ON
French version
tS
ON
toll saver on
r4
ON
toll saver off
TROUBLESHOOTING GUIDE
1
Will not operate
Are the power supply and telephone line
cords plugged into the DAS-204 and the
appropriate power/telephone jacks of
your residence/business?
2
LED indicator lights are off
Is the phone line cord or power supply
properly plugged in?
3
Cannot turn on ANSWER key Have you recorded an outgoing message
(A1/A2)?
4
Will not record the incoming
Is Answer Only (A2) on?
message
Is your memory full? The DAS-204 will
record up to 40 minutes of messages.
5
Cannot operate remote
Is your security code correct?
control
6
Cannot play the current time
Does clock need to be set or reset?
7
Message playback too loud
Adjust volume control at side of unit to
or difficult to hear
desired level.
8
LED indicates “88” or number
Unplug unit, remove battery, and
of keys will not operate
plug it back in. This resets the DAS-204.
9
OGM1 and OGM2 are erased
Back-up battery power low or absent.
Replace with a fresh battery.
15
14