Loading paper in the tray, In the tray – Samsung CLP-320 User Manual
Page 54
Media and tray_ 54
•
Do not use a paper with more than 6 mm (0.24 inch.) curl.
5.
Close the paper cover.
6.
Slide the tray back into the machine until it clicks.
7.
Set the paper type and size for the tray ("Setting the paper size and
If you experience problems with paper feeding, check whether the
paper meets the media specifications. Then, try placing one sheet
at a time in tray (See "Print media specifications" on page 92 or
see "Printing on special media" on page 56).
The tray is preset to Letter or A4 size, depending on your country. To
change the size to A4 or Letter, you must adjust the lever and paper width
guide properly.
1.
Pull the tray out of the machine. Open the paper cover and remove
paper from the tray if necessary.
2.
If you want to change the size to Letter, hold the lever at the back of the
tray, and rotate the lever clockwise.
LTR
A4
3.
Squeeze the paper width guide and slide it to the edge of the lever.
LT
R
A4
If you want to change the size to A4, first move the paper width
guide to left and rotate the lever counterclockwise. If you force the
lever, it could damage the tray.
Loading paper in the tray
In the tray
1.
Pull out the paper tray. Adjust the tray size to the media size you are
loading (See "Changing the tray size" on page 53).
2.
Flex or fan the edge of the paper stack to separate the pages before
loading the paper.
3.
Place the paper with the side you want to print facing up.
4.
Squeeze the tray paper guides and adjust them to the width and length
of the paper. Do not force them too much or the paper will be bent result
in a paper jam or skew.
5.
Close the paper cover.