Vga enable/disable, Jlan enable/disable, C to pci-x slots – SUPER MICRO Computer Super H8QM3-2 User Manual
Page 32: C to pci-e slots, Compact flash master/slave
2-14
H8QM3-2/H8QMi-2 User's Manual
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
JLAN Enable/Disable
Change the setting of jumper JPL1
to enable or disable the JLAN1 and
JLAN2 Gb Ethernet ports. See the
table on the right for jumper settings.
The default setting is enabled.
JLAN1/2 Enable/Disable
Jumper Settings (JPL1)
Jumper Setting Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
I
2
C to PCI-X Slots
Jumpers JI
2
C1 and JI
2
C2 allow you to
connect
the
PCI-X slots to the I
2
C (Sys-
tem Management) bus
.
The default
setting is disabled. Both jumpers must
be set to the enabled or disabled set-
ting for this feature to function. See the
table on the right for jumper settings.
I
2
C to PCI-X Slots
Jumper Settings (JI
2
C1, JI
2
C2)
Jumper Setting Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
I
2
C to PCI-E Slots
Jumpers JI
2
C3 and JI
2
C4 allow you to
connect
the
PCI-E slots to the I
2
C (Sys-
tem Management) bus
.
The default
setting is disabled. Both jumpers must
be set to the enabled or disabled set-
ting for this feature to function. See the
table on the right for jumper settings.
I
2
C to PCI-E Slots
Jumper Settings (JI
2
C3, JI
2
C4)
Jumper Setting Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
Compact Flash Master/Slave
The JCF1 jumper allows you to assign
either master or slave status to a com-
pact fl ash card installed in the IDE#1
slot. You will need to connect compact
fl ash power to JWF1 to use. See the
table on the right for jumper settings.
Compact Flash
Master/Slave
Jumper Settings (JCF1)
Jumper Setting Defi nition
Closed
Master
Open
Slave