Steamfast SF-140 - Manual (Page 7)

a
ssembLIng the
S
team
m
op
Top Innovations 7
TELESCOPIC POLE
1. Connect Handle to thicker (upper) end of Telescopic Pole. To do this, simply slide Handle onto
Pole until it snaps in place (FIGURE 1-A).
NOTE: Once connected, the Handle cannot be removed from Telescopic Pole.
2. Insert thinner (lower) end of Telescopic Pole into bracket on top side of Mop Head. When
inserting, make sure release button located on Pole faces towards back side of bracket as illustrated
(FIGURE 1-B). Note small indention along edge of bracket hole, which is designed for release
button to pass.
3. Press Telescopic Pole into bracket until release button snaps through small hole on back side of
bracket (FIGURE 1-C). Pole should now be secured to Mop Head.
NOTE: In order to coax the release button through the hole, it may be necessary to rotate
and adjust the Telescopic Pole until button aligns properly with hole.
4. To adjust length of Telescopic Pole, press Extension Lock downward. While holding the Lock
down, move the upper section of the Pole until it is at the desired length (FIGURE 1-D). Release
Lock, then adjust upper section of Pole again until it “clicks” securely into place.
5. To disconnect Telescopic Pole, swivel lower Cord Bracket 180º upward, then press firmly on
release button while simultaneously pulling Pole away from Mop Head bracket (FIGURE 1-E).
FIGURE 1
A B C D E