Shindaiwa 68006-94310 - Manual (Page 24)

24
The engine does not start.
PROBLEM
Remove the spark plug (pg 13).
Is the spark �
plug wet?
Cutting performance is poor.
PROBLEM
Make sure the choke is �
pushed fully in.
Make sure the air �
cleaner is clean (pg 17).
Make sure the drive belt is �
properly tightened (pg 19).
Make sure the carburetor is �
is properly adjusted (pg 18).
Make sure the cut-off wheel is
appropriate for your work.
Make sure the diamond �
wheel is sharp.
Dry the �
spark plug.
Inspect the
spark plug �
(pg 19).
Pull the recoil
starter several
times to
remove fuel
from the
cylinder.
If the above inspections and maintenance procedures do not �
correct the problem, contact your Shindaiwa dealer for assistance.
Make sure the fuel tank contains
with clean, fresh fuel (pg 11).
Is the spark �
plug dry?
Replace the �
fuel filter �
(pg 22).
Troubleshooting