SoundCraft DAKOTA 328 - Manual (Page 6)

Dakota Setup Guide
5
Set the desired wordlength on the 328 with the rotary encoder.
Press the down cursor to set the port for 328 ADAT port B, as for port A, and again to set the
wordlength for port B. Press <ENTER> to confirm the settings.
The 328 S/PDIF input can be routed to any one of the following inputs:
Stereo Input 1, Stereo Input 2, FX Return 1, FX Return 2, 2 Track Tape Return,
providing that the AES/EBU input or oscillator has not already been assigned to that input.
Commonly the Dakota S/PDIF output would be routed to Stereo Input 2, or the 2 Track Tape
Return input.
Press <MENU> to enter the menu pages, scroll through the pages until the ‘SPDIF I/P Setup’ is
highlighted and press <ENTER>. Using the rotary encoder, select the destination for the
S/PDIF input, and press <ENTER> to confirm the setting:
< SPDIF Input >
Route To: STE-1 < SPDIF Input >
Route To: FX-1
< SPDIF Input >
Route To: 2TRK < SPDIF Input >
Route To:NOWHERE
<Tape Ch17->24 >
Wordlength: 24
S/PDIF Input S/PDIF Input S/PDIF Input S/PDIF Input
<Tape Ch25->32 >
Bank Source:ADAT
<Tape Ch25->32 >
Wordlength: 24
Assigning a digital source to an input will override any analogue signal
present on that input.
NOTE
If the S/PDIF input is not required, NOWHERE should be selected in the
menu.
NOTE