Samsung SCX-RD100 - Manual (Page 8)

8 – COAXIAL REMOTE CONTROLLER
Introduction
RS-485 TERMINATION & PROTOCOL Setting Switch
- You can select to set the RS-485 termination.
- Turn this switch ON, if RS-485 termination is required.
TERMINATION
1
ON
2
PROTOCOL
1
ON
2 3 4 5 6 7 8 1
ON
2 3 4 5 6 7 8
PROTOCOL
- For multi-protocol settings, you can set the protocol and baud rate, and
selection of COAXIAL/RS-485 or RS-232.
TERMINATION
1
ON
2
PROTOCOL
1
ON
2 3 4 5 6 7 8 1
ON
2
TERMINATION
- Use pin 1,2,3,4 of the Protocol setting switch to select a protocol.
- Use pin 5,6 of the Protocol setting switch to select a baud rate.
- Use pin 7 of the Protocol setting switch to select COAXIAL/RS-485 output.
- Use pin 8 of the Protocol setting switch to select RS-232 input.
Address Switch
- For RS-232 / RS-485 communications, you can use this switch to set the address.
ADDRESS
(X)100 (X)10 (X)1
5
0
4
9
3
8
2
7
1
6
5
0
4
9
3
8
2
7
1
6
5
0
4
9
3
8
2
7
1
6
- Set the address by using three switches shown above.
- From the left, the number is hundreds, tens and ones place, respectively.
The effective range of valid address is between 0 and 255 (1~255 for multi-
protocol).
Menu Navigation Key
Use this to navigate through the menus.
❺
❻
❼
❖
P
N
If you specify the address as other than between 0 and 255, it will be set to 0. ƒ
NOTE