Siemens CX70 - Manual (Page 45)

©
Sieme
ns
AG
2003, \\De
llserve
r\users\a
d
min\Ulysse
s Refresh\E2\S_U
LYR_Setup.fm
Setup 44
VAR Langua
ge: en; V
A
R issue
date: 040604
left page (44) of Ulysses_Refresh SUG en2 short, A31008-H7103-M7-1-RC19 (30.11.2004, 12:56)
Call setup
C
¢
T
¢
Call setup
¢
Select function.
Hide ID
b
If activated, your phone number will
not appear on the other party’s dis-
play (depending on the service pro-
viders).
Call waiting
b
If you are registered for this service,
you can check whether it is set and
you can activate/deactivate it.
Divert
You can specify when calls should be
diverted to your mailbox or other
numbers.
Set up call divert (example)
Unanswered
b
I
Select Unanswered .
(Includes the conditions
Not reachable , No reply ,
Busy , see below)
C
Confirm and select Set ,
then enter the phone
number to which the call
will be diverted.
C
Confirm. The network set-
ting confirms.
All calls
b
All calls are diverted.
Ç
Icon in the top line of the
display in standby mode.
Other possibilities for divert:
Not reachable , No reply , Busy , Receiving
fax , Receiving data
Call screening
Only calls from phone numbers that
are in the Phonebook/Addressbook
or in a group are signalled. Other
calls are only displayed.
Any key answ.
Incoming calls can be accepted by
pressing any key (except for
B
).
Minute beep
During the call, you (and only you!)
will hear a beep after each minute as
a reminder of the time elapsed.