Swisher FC-10 - Manual (Page 6)

Step 3: Attaching the Tongue Support
Attach the Tongue Support(#3) to the Bottom Panels as shown in Figure 3 using 2
(#22) Bolts, 2 (#23) Washers, and 2 (#24) Nuts.
Hardware Needed for Step 3:
2 (#22) Bolts
2 (#24) Nuts 2 (#23) Washers
2 (#23) Washers
Step 4: Assemble Wheel Axle Supports
As shown in Figure 4 below, connect together the 2 Wheel Axle
Supports (#4) using 8 (#25) Bolts, 8 (#23) Washers, and 8 (#24) Nuts.
DO NOT TIGHTEN BOLTS—leave bolts very loose for inserting axle
and tongue in Step #6.
Hardware Needed for Step 4:
2 (#4) Wheel Axle Supports
8 (#25) Bolts
8 (#23) Washers
8 (#24) Nuts
Page 6