Watching tv, Preparation, Turning on the power – Sharp Aquos LC 20DV20U User Manual

Page 14: Select the tv mode, Turning off the power, Changing channels, Changing volume/sound

Advertising
background image

13

Changing channels

You can change channels in several ways.

Simple operations for watching a TV program

POWER indicator

Turning on the power

Press POWER on the TV/DVD, or POWER on the

remote control.

• POWER indicator (Green): The TV/DVD is on.

NOTE

• The LANGUAGE setup menu will appear automatically

when TV MENU is pressed on for the fi rst time.

Turning off the power

Press POWER on the TV/DVD, or POWER on the

remote control.

• The TV enters standby mode and the image on the

screen disappears.

• The POWER indicator on the TV/DVD changes to Red.

NOTE

• If you are not going to use this TV/DVD for a long period

of time, be sure to remove the AC cord from the power

outlet.

• Weak electric power is still consumed even when

POWER is turned off.

• If a station being viewed stops broadcasting, the TV will

automatically shut itself off after 15 minutes.

Preparation

Perform the following steps before you press POWER

on the remote control unit.

1. Insert the batteries into the remote control unit.

(See page 8.)

2. Connect the antenna cable to the TV/DVD. (See page

12.)

3. Plug in the AC cord to the AC outlet. (See page 7.)

Watching TV

POWER

TV/DVD status indicator (POWER)

ON

Lighting (Green)

Lighting (Red)

OFF/Standby

To select a 3-digit channel number (e. g., Channel 115):

Press 1J1J5

NOTE

• When selecting a 1-digit channel number, it is not

necessary to press 0 before the number.

• If you push “0” by itself, nothing will happen.

• Complete the above steps within a few seconds.

Method 1
Using CH

/

on the remote control unit or on the

TV/DVD.
Method 2
Using remote control buttons 0

9 to select channels

for VHF/UHF/CATV.

To select a 1 or 2-digit channel number (e. g., Channel 5):

Press 5

VOLUME 25

Changing volume/sound

Changing the volume
You can change the volume on the TV/DVD or on the

remote control unit.

NOTE

VOL+/– on the TV/DVD operates the same as VOL+/–

on the remote control unit.

Using VOL +/–

• To increase the volume, press

VOL +

.

• To decrease the volume, press

VOL –

.

MENU VOL +/– CH

/

Select the TV mode

Press TV/DVD to select the TV mode.

5X20431A_P01-15.indd 13

5X20431A_P01-15.indd 13

5/19/2006 10:51:32 PM

5/19/2006 10:51:32 PM

Advertising