Shindaiwa Multipurpose Pole Pruner Attachment 78701 T230 - Manual (Page 11)

11
Apply the adhesive
caution labels
Figure 21
1. Clean outer tube so the labels will adhere properly.
2. Peel the backing off the multiple warning label and attach below similar label on
lower part of outer tube. Make sure label faces up and that it is legible from the
operator's position.
3. Peel the backing off "The Electrical Shock Danger" label and attach it just ahead of
the throttle grip. Make sure the label faces up and that it is legible from the opera-
tor's position.
Installing the Caution Labels
WARNING!
■
The provided labels offer important safety information about pole pruners. Do
not operate, or allow others to operate, this machine unless the labels are prop-
erly installed.
Installing the Cutting Head Assembly
Push the outer tube
into the gearcase
clamp
Figure 22
Index
screw
Align the index
screw with the hole
in the tube
Tighten Index
screw first
Tighten clamp
screw last
Figure 23
Use a 4mm hex (Allen) wrench to
loosen clamp screws
Figure 24
Move the handle to
the best position, then
retighten
1. Insert the end of the outer tube into the pole saw gearcase clamp assembly and
push until it bottoms. The outer tube should go into the gearcase about 1-1/2
in. (38 mm). If the outer tube stops before bottoming, rotate it until you feel the
inner mainshaft (driveshaft) splines engage the gearcase. Then push the outer
tube all the way in. See Figure 23.
2. Rotate the gearcase assembly so that the index screw aligns with hole in outer
tube.
3. Use a 4 mm hex (Allen) wrench to tighten the gearcase index screw first, then
the gearcase clamp screw.
Adjust Loop Handle
1. Shindaiwa recommends leaving the T230 or PB230 loop handle on the outer tube.
However, for maximum comfort and control, it may require adjustment. Use
the 4 mm hex (Allen) wrench to loosen the handle's four clamp screws. Move
the handle along the tube to the point where the most comfort and control are
observed. Retighten the clamp screws.