Shindaiwa Multipurpose Pole Pruner Attachment 78701 T230 - Manual (Page 16)

16
WARNING!
Before performing any maintenance,
repair, or cleaning work on the unit,
make sure the engine and cutting
attachment are completely stopped.
Disconnect the spark plug wire
before performing service or mainte-
nance work.
IMPORTANT!
For detailed maintenance information
about your T230/231, AH230/231, or
PB230 , consult the owner's manual that
was provided with it. If it has been lost
or misplaced, contact Shindaiwa for a
replacement.
Maintenance
WARNING!
Non-standard parts may not oper-
ate properly with your unit and may
cause damage and lead to personal
injury.
IMPORTANT!
Using non-standard replacement parts
could invalidate your Shindaiwa war-
ranty.
Prior to each work day, perform the follow-
ing:

Clean any debris or dirt from the
cutting attachment. Check the bar
and chain for damage or incorrect
adjustment.
Daily Maintenance
WARNING!
The saw chain is very sharp. Wear
gloves to protect your hands when
working with or around the saw
chain.
 Check for loose or missing screws or
components. Make sure the cutting
attachment is clean, free of debris and
securely fastened.
 Check the entire machine for leaking
fuel or grease.
 Make sure that nuts, bolts, and
screws (except carburetor adjusting
screws) are tight.
15-hour Maintenance
Every 15 hours of operation
(more frequently in dusty or dirty
conditions):
 Remove the sprocket cover and
inspect the sprocket (A) for excessive
dirt, debris, or wear. Remove the
guide bar and clean out the guide bar
groove. If the sprocket is excessively
worn, replace it with a new one.
A