Samson XM910 - Manual (Page 26)

24
Specifications
SPECIFICATIONS
Rated Output power 2 X 450W at 4
Ω
@0.1% THD at 1KHz
Frequency response 20Hz~20KHz+/-0.7dB@1W Output into 8
Ω
(AMP OUT)
20 Hz~20KHz+/-0.4@+4dB Output into 10k
Ω
(MAIN OUT,
MONITOR OUT, AUX 2 SEND)
Total Harmonic Distortion Less than 0.06%@20Hz~20KHz, 75W output into4
Ω
(AMP
OUT)
Less than 0.1%@20 Hz~20KHz+14dB output into 10K
Ω
(MAIN OUT, MON OUT, AUX 2 SEND)HUM & Noise -121dB
equivalent input noise
(Average, RS+150
Ω
) -100dB residual output noise (MAIN OUT, MONITOR OUT, AUX
2 OUT)
(with 22Hz~22KHz BPF) -79dB (MAIN OUT, MONITOR OUT) Master level control at
maximum, all channel level control at minimum.
-79dB (AUX 2) Master level control at maximum, all channel
level controls at minimum
Maximum Voltage Gain 67dB CH IN (MIC) to AMP OUT
63dB CH IN (MIC) to MAIN OUT, MONITOR OUT
54dB CH IN (MIC) to AUX 2 OUT
30dB CH IN (MIC) to REC OUT
32dB CH IN (LINE) to MAIN OUT, MONITOR OUT
26dB AUX IN to MAIN OUT
24dB TAPE IN to MAIN OUT
Crosstalk 1KHz 70dB adjacent input, 70dB input to output
Input Channel Equalization HIGH 12KHz shelving (+/- 15dB Maximum)
MID 2.5KHz peaking (+/- 12dB Maximum)
LOW 80Hz shelving (+/- 15dB Maximum)
Meters 9 POINT LED METERS (-20, -15, -10, -7, -4,-2, 0, +2, +4dB)
Graphic Equalizer 10 bands (30, 63, 125, 250, 500, 1K, 2K, 4K, 8K, 16KHz)
Internal DSP Effects 24 BIT - 10 Presets each: 1 - Performance; 2 - Hall Reverb, 3 -
Plate Reverb; 4 - Spring Reverb; 5 - Echo; 6 - Flange +
Verb; 7 - Chorus + Verb; 8 - Echo + Verb; 9- Chorus;
10- Flange
Phantom Power +48V
CLIP Indicators Turn on: THD> 0.1%
Foot Switch DIGITAL EFFECT MUTE: ON/OFF
GENERAL
Power Requirement 110V-240V, 50/60Hz
Power Consumption 950W, MAX.
Weight 40 lbs./18.2Kg
Dimensions 21” (W) x 14” (H) x 13-3/4” (D)
534mm(W) x 356mm(H) x 350mm(D)